A Proposed Model for Estimating the Relative Bond Strength of RC Beam with Corroded Lap Spliced Steel Bars, considering c/db

Document Type : پژوهشی

Authors

• Yaser Moodi
• Mohammad Reza Sohrabi
• Seyed Roohollah Mousavi

University of Sistan and Baluchestan

10.22067/civil.v32i3.64984

Abstract

Corrosion of lap spliced region causes the bond strength to change. The ratio of the bond strength in the corrotion state to the value of its corresponding in the absence of corrosion is called the relative bond strength. The results of the relative bond strength are different in Pullout test, Tension stiffening test and Beams with lap spliced bars test. The results of theTension stiffening test in the literature is more similar to those of Beams with lap spliced bars. In this study, a model has been proposed using tension stiffening tests, for determining the relative bond strength of corroded steel bars in the descending branch. Finally, this model has been optimized using genetic algorithm for determining the relative bond strength of RC Beam with corroded lap spliced steel bars. The current study shows that using the proposed model will lead to the beter result. The use of proposed model for the estimating the relative bond strength of RC beam with corroded lap spliced steel bars, leads to about 16 percent reduction in total error compared with Shihata model.

Keywords

• Reinforce concrete
• corrosion
• Bond strength
• Lap spliced

---

References

[1] Duan, A., Dai, J.G. and Jin, W.L., "Probabilistic approach for durability design of concrete structures in marine environments", ASCE, Journal of Materials in Civil Engineering, Vol. 27, No. 2, pp. 1-8, (2014).

[2] Cairns, J., Du, Y. and Law, D.W., "Structural performance of corrosion-damaged concrete beams", Magazine of Concrete Research, Vol. 60, No. 5, pp. 359-370, (2008).

[3] Al Sulaimani, G.J., Kaleemullah, M., Basunbul, I.A. and Rasheeduzzafar, "Influence of Corrosion and Cracking on Bond Behavior and Strength of Reinforced Concrete Members", ACI, Structural Journal, vol. 87, No. 2, pp. 220-231, (1990).

[4] Shayanfar, M.A. and Ghalenovi, M., "Corrosion effects on tension stiffening behavior Reinforced Concrete", Computers and Concrete, vol. 4, No. 5, pp. 403-424, (2007).

[5] Law, M.W., Tang, D., Molyneaux, T.K.C. and Gravina, R., "Impact of crack width on bond: confined and unconfined rebar", Materials and Structures, Vol. 44, No. 7, pp. 1287-1296, (2011).

[6] Tondolo, F., "Bond behaviour with reinforcement corrosion", Construction and Building Materials, Vol. 93, pp. 926–932, (2015).

[7] Zhang, X., Liang, X., Wang, Z., Huang, H. and Zhou, H., "An Experimental Study on Effect of Steel Corrosion on the Bond–Slip Performance of Reinforced Concrete", 5th International Conference on Durability of Concrete Structures, (2016).

[8] Lee, H.S., Noguchi, T. and Tomosawa, F., "Evaluation of the bond properties between concrete and reinforcement as a function of the degree of reinforcement corrosion", Cement and Concrete Research, vol. 32, No. 3, pp. 1313-1318, (2002).

[9] Yalciner, H., Eren, O. and Sensoy, S., "An experimental study on the bond strength between reinforcement bars and concrete as a function of concrete cover, strength and corrosion level", Cement and Concrete Research, vol. 42, No. 5, pp. 643–655, (2012).

[10] Zhang, W.P., Chen, H. and Gu, X.L., "Bond behaviour between corroded steel bars and concrete under different strain rates", Magazine of Concrete Research, vol. 68, No. 7, pp. 364-378, (2016).

]11[ مستوفی‌نژاد، د.، "سازه‌های بتن آرمه (جلد دوم)"، اصفهان، انتشارات ارکان دانش، (1388).

[12] Amleh, L. and Mirza, S., "Corrosion Influence on Bond between Steel and Concrete", ACI, Structural Journal, vol. 96, No. 3, pp. 415-423, (1999).

[13] Dai, J., Kato, E., Iwanami, M. and Yokota, "Cracking and tension stiffening behavior of corroded RC members", Report of the port and airport research institute, vol. 46, No. 2, pp. 1-24, (2007).

[14] Aryanto, A. and Shinohara, Y., "Bond Behavior between Steel and Concrete in Low Level Corrosion of Reinforcing Steel", 15 WCEE, (2012).

[15] Kim, H.R., Choi, W.C., Yoon, S.C. and Noguchi, T., "Evaluation of Bond Properties of Reinforced Concrete with Corroded Reinforcement by Uniaxial Tension Testing", International Journal of Concrete Structures and Materials, vol. 10, No. 3, pp. 43-52, (2016).

[16] Shihata, A., "CFRP strengthening of RC beam with corroded lap spliced steel bars", Master of Applied Science Thesis, University of Waterloo, Waterloo, Canada, (2011).

[17] Bhargava, K., Ghosh, A.K., Mori, Y., Ramanujam, S., "Suggested Empirical Models for Corrosion-Induced Bond Degradation in Reinforced Concrete", Journal of Structural Engineering, vol. 134, No. 2, 2008, pp. 221–230.

[18] Cabrera, J.G., "Deterioration of concrete due to reinforcement steel corrosion", Cement and Concrete Composite, vol. 18, No. 1, 1996, pp. 47–59.

[19] Chung, L., Kim, J.J. and Yi, S., "Bond strength prediction for reinforced concrete members with highly corroded reinforcing bars", Cement and Concrete Composite, vol. 30, No. 7, 2008, pp. 603–611.